Toshiba e-STUDIO500P Service Manual page 70

User attendance messages (continued)
Error Sub
Primary message
code code
Disk Corrupted
Reformat?
Empty Box M
Insert Box M
Insert Cartridge or Close
Door
Insert Staple Cartridge
2-34
Service Manual
Description/action
The printer has detected there are errors on the hard disk that cannot be
corrected. The disk cannot be used until it is reformatted.
Warning: All data on the disk will be lost if you format the disk.
The following actions can be taken:
• Power off and remove the disk. The disk will not be formatted.
• Press to format the disk. All data is lost when you format the disk.
This message is displayed when the hole punch alarm is on and the printer
informed by the code the hole punch box M is full. The following actions may
be taken:
• Empty the hole punch box.
to ignore the message. The Box M Full appears on line 2 of
• Press
the display and the job is printed without hole punching. The message
remains until the box is emptied.
If this message continues to be displayed when the box has been emptied,
go to "StapleSmart finisher service check" on page
This message is displayed when the hole punch box is missing or installed
incorrectly. The message is displayed during any of the following times,
regardless of the hole punch alarm setting:
• At POST
• After the finisher side door has been closed
• Before the first page of a job requesting hole punch. The message
displays once per job.
The following actions can be taken:
• Install the hole punch box.
to ignore the message. The Box M Missing message
• Press
appears on the status line. A job that is set for hole punching will not be
punched. The message continues to display on all subsequent jobs that
request hole punching.
If this message cannot be cleared after inserting the box, go to
"StapleSmart finisher service check" on page
This message displays when the printer front door is open or the print
cartridge is missing.
If this message cannot be cleared, go to
service check" on page 2-80.
This message displays when the staple cartridge is missing or installed
incorrectly. The message appears, regardless of the Staple Alarm setting, at
the following times:
• At POR
• After the Stapler Door has been closed.
The following actions can be taken:
• Install the stapler cartridge.
• Press to clear the message. The printer handles stapled jobs as if
the staple cartridge were installed, but empty. The Staples Empty
message appears on the status line and the Load Staples may display.
2-123.
2-123.
"Cover closed switch/cable