Font Sharpening; Lcd Brightness; Lcd Contrast; Exit Config Menu - Toshiba e-STUDIO500P Service Manual

Font Sharpening

This setting allows a user to set a text point size below which the high frequency screens are used when printing
font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency screens.
The values for this setting range from 0 to 150, and the default value is 24. This setting affects PostScript, PCL,
and XL.
To change the value, select Font Sharpening from the CONFIG MENU, and use
to increase the value. Select

LCD Brightness

This setting allows the user to increase or decrease the brightness of the operator panel LCD. When the value is
increased, the backlight shines brighter, and when the value is decreased, the backlight is dimmer. The operator
panel responds immediately to the changes. Use
values range from 1 to 10, and 5 is the default value.

LCD Contrast

When this setting is selected, the operator panel displays a gray bar with a slider representing the values. As the
values are decreased, the bar appears darker, and when the values are increased, the bar appears lighter.
Changes to this setting immediately change the operator panel. The range of values is between 1 and 10, and
the default value is 5.

Exit Config Menu

to exit the CONFIG MENU. The message Resetting the Printer displays, and the printer
Press
performs a POR and restarts in normal mode.

Additional useful menu locations

User menus are available from the Ready state by pressing Menu (

Hex Trace

To turn Hex Trace on:
1.
Press Menu (
2.
Press
3.
Press .
4.
Press
5.
Press .
6.
Press
7.
Press .
8.
Press
Trace.
to accept the value.
to display Menus.
)
appears next to Settings.
until the
appears next to Utilities Menu.
until the
appears next to Hex Trace.
until the
again to select Activate, or press Back (
to decrease the value and
).
) to return to Utilities Menu without activating Hex
to decrease the value and
to increase the value. The
3-29
Diagnostic aids