Exiting Diagnostics Mode; Registration - Toshiba e-STUDIO500P Service Manual

Diagnostics mode tests (continued)
EP SETUP
EP Defaults
Fuser Temp
Fuser Page Count
Warm Up Time
Transfer
Print Contrast
Charge Roll
Gap Adjust
EVENT LOG
Display Log
Print Log
Clear Log
EXIT DIAGNOSTICS

Exiting Diagnostics mode

Select Exit Diagnostics to exit the Diagnostics mode. Resetting the Printer displays, the printer
performs a POR, and returns to normal mode.

REGISTRATION

Print registration makes sure the printing is printed properly aligned on the page.
The settings available are:
Bottom Margin
Top Margin
Left Margin
Right Margin
Quick Test
To set print registration:
1.
Select REGISTRATION from the DIAGNOSTICS menu.
2.
Select Quick Test, and press
To print the Quick Test page:
a.
Press
b.
Press
The message Quick Test Printing... appears on the display.
Retain this page to determine the changes you need to make to the margins settings.
3-4
Service Manual
See "EP Defaults" on page 3-22
See "Fuser Temperature (Fuser Temp)" on page 3-22
See "Fuser Page Count" on page 3-22
See "Warm Up Time" on page 3-22
See "Transfer" on page 3-22
See "Print Contrast" on page 3-22
See "Charge Roll" on page 3-22
See "Gap Adjust" on page 3-22
See "Display Log" on page 3-23
See "Print Log" on page 3-23
See "Clear Log" on page 3-24
.
appears next to Quick Test.
until the
.