Low Voltage Power Supply Removal - Toshiba e-STUDIO500P Service Manual

Low voltage power supply removal

CAUTION: Unplug the printer before you begin.
1. Remove the redrive assembly. See
2. Remove the right side cover. See
3. Remove the pass thru plate. See
4. Remove the LVPS mounting screws (A) from the rear of the center pan.
5. Disconnect the LVPS to system board cable.
The cable is difficult to disconnect. There are catches (B) that firmly hold latches on the LVPS
card connector (C).
4-54
Service Manual
"Redrive assembly removal" on page 4-74.
"Right cover removal" on page 4-8.
"Pass thru plate" on page 4-18.