Automatic Connection; Searching For Cell Phones - Becker BE A00 Operating Manual

Automatic connection

After activation, your Navigation device
attempts to establish a connection to the
cell phone last connected.
Note:
The cell phone last connected is then
only connected if no protected device is
in front of this device in the device list.
You can switch this function on or off as
described in "Automatic connection" on
page 121.
Prerequisites for a successful connec-
tion are:
• On your Navigation device, Bluetooth®
is switched on. (See "Bluetooth" on
page 120.)
• The cell phone is switched on, is within
range, and Bluetooth® is activated.

Searching for cell phones

Note:
Prior to a search, switch on Bluetooth®
on the cell phone to be searched for.
> Call up the device list.
> Press the
Search Bluetooth phones
button.
The search starts.
During the search, any devices found are
displayed and you may cancel the search
by pressing the Stop search
After the search or after you press the
Stop search
, a list of the devices found is
displayed.
> Then select the name of the cell phone
to be connected.
The Navigation device will then attempt
to establish the connection. On the cell
phone, the password prompt should
then occur. This password is fixed by
Navigation device.
button.
> Enter the password displayed on the
cell phone.
The connection will be established. With
a successful connection, the telephone
menu will be displayed.
TELEPHONE MODE >>>
> D
> GB
> F
> I
> PL
115