Fitting The Unit Bracket; On The Windscreen - Becker BE A00 Operating Manual

Unit bracket
The Navigation device can be attached
directly to the windscreen with the unit
holder.
Note:
The Navigation device and unit bracket
must not be exposed to long periods of
direct sunlight. Temperatures inside the
vehicle of +70 °C and higher may
damage parts of the bracket.

Fitting the unit bracket

Note:
Fasten the unit holder such that your
field of vision is not impaired when the
Navigation device is installed and
ensure that the unit is outside the
deployment area of the airbag.
Ensure that the electrical connection
cable does not hamper you from
accessing the vehicle's controls.
Clean the attachment surface on the
windscreen to ensure that it is clean and
free of grease. Do not use greasy or
soapy cleaning agents.
2
1
6 4 3
Suction surface
1
Base
2
Lever
3
Fastening screw
4
Carrier plate
6
GENERAL OPERATION

On the windscreen

The unit holder can be attached directly
to the windscreen using the suction
mechanism.
> Press the carrier plate onto the four
retaining lugs of the unit holder.
> Select a suitable spot to attach.
> Loosen the fastening screw
> Press the base
with its suction
2
surface against the windscreen.
1
Turn the unit holder such that the
carrier plate is positioned roughly in
the desired viewing direction.
> Press the lever
down.
3
The holder has attached itself firmly to
the windscreen. It can now be adjusted
with precision. In order to remove it,
operate the lever again.
3
>>>
> D
> GB
> F
> I
slightly.
4
> PL
23