Cable For Vehicle Integration (Depending On Model, Optional); Cable For Rear View Camera (Depending On The Model, Optional) - Becker BE A00 Operating Manual

>>> GENERAL OPERATION
Cable for vehicle integration
> D
(depending on model, optional)
> GB
With a 4-pin 2.5mm jack cable you can
integrate your
> F
seamlessly into your vehicle.
> I
• connect your Navigation device to the
phone mute function of your audio
> PL
system. If the cable is connected
correctly, your audio system will mute
the car radio during navigation
announcements.
• connect your Navigation device to your
audio system for output of the audio
signal.
GND
Telephone Mute:
Audio-R
Audio-L
> Insert the cable into the 2.5mm socket
provided on the back of the basic unit,
also see Seite 17.
22
Note:
Once the cable is connected, the
loudspeaker of the basic device is
switched off. The Tel-Mute function
Navigation device
cannot be used with the cable supplied.
A
manufactured for this.
cable must be individually
Cable for rear view camera
(depending on the model,
optional)
You can connect your rear view camera
to your navigation device using a 4-pin
2.5mm AV cable. Insert the cable into the
socket provided on the back of the basic
unit, also see Seite 17.
GND
Video
Audio-R
Audio-L
You can make the necessary settings in
the chapter "Reversing camera" on page
127.