Using The Battery; Connection For The Cigarette Lighter - Becker BE A00 Operating Manual

>>> GENERAL OPERATION

Using the battery

> D
The internal power supply is via the
integrated rechargeable battery. The
> GB
rechargeable battery is maintenance-
free and does not require any particular
> F
care.
> I
You are alerted by a warning message
when the battery should be recharged.
> PL
After the alert, the device can still be
used for approximately 10 minutes
before switching off automatically.
Note:
Note that if the battery is completely
discharged, it may take up to a minute
before the device can be switched on
again.
Note:
In the event of a defective battery,
please contact your authorised dealer.
Please do not attempt to remove the
battery yourself.
20

Connection for the cigarette lighter

Note:
If the cigarette lighter has recently been
used and is still hot, wait until the lighter
socket has cooled down.
Connect the power supply via the vehicle
battery and the cable provided for the
cigarette lighter as follows:
> Grasp the connector of the connection
cable and insert it gently without force
into the connector socket of the
navigation device up to the stop, or in
the case of a device with an active
cradle, on the underside of the
supporting plate.
> Insert the adapter into the cigarette
lighter.
Note:
When the engine is switched off, the
power supply slowly discharges the
vehicle battery via the cigarette lighter!
Do not therefore operate the Navigation
device for long periods with the engine
switched off.
To receive TMC messages (depending
on the model), the power supply must
be connected to the supporting plate in
the case of a device with an active
cradle.