Automatic Connection; Searching For Cell Phones - Becker Active 43 Series Operating Instructions Manual

Selection Significance
The device is protected
Protect entry
against automatic dele-
tion (only available for
unprotected devices).
The protection of the de-
Remove
vice is canceled (only
protection
available for unprotected
devices).
/ The device is moved one
Move up
position forwards/back-
Move down
wards.
The device is deleted
Delete
from the device list.
All devices are deleted
Delete All
from the list (even the
protected entries).

Automatic connection

After activation, your Navigation device
attempts to establish a connection to the
cell phone last connected.
Note:
The cell phone last connected is then
only connected if in the device list no
protected device is in front of this device.
You can switch this function on or off as
described in "Automatic connection" on
page 112.
Prerequisites for a successful connection
are:
• For your Navigation device, Blue-
tooth® is switched on. (See "Switching
Bluetooth on and off" on page 112.)
• The cell phone is switched on, is in
range, and Bluetooth® is activated.
TELEPHONE MODE

Searching for cell phones

Note:
Prior to a search, switch on Bluetooth®
on the cell phone to be searched for.
> Call up the device list.
> Press the
Search Bluetooth phones
button.
The search starts.
During the search, any devices found are
displayed and you may cancel the search
by pressing the button.
Stop search
After the search or after you press the
button, a list of the devices found
search
is displayed.
>>>
> D
> GB
> F
> I
> E
> PL
> CZ
> H
> RU
Stop
107