Automatic Connection; Searching For Cell Phones - Becker Ready 50 Operating Manual

>>> TELEPHONE MODE
> D
> GB
> F
> I
Selection
> PL
Protect entry
Remove
protection
Move up
/
Move down
Delete
Delete All
114

Automatic connection

After activation, your Navigation device
attempts to establish a connection to the
cell phone last connected.
Meaning
The device is protected
You can switch this function on or off as
against automatic dele-
described in "Automatic connection" on
tion (only available for
page 120.
unprotected devices).
The protection of the de-
Prerequisites for a successful connec-
vice is canceled (only
tion are:
available for unprotect-
• On your Navigation device, Bluetooth®
ed devices).
The device is moved one
position forwards/back-
• The cell phone is switched on, is within
wards.
The device is deleted
from the device list.
All devices are deleted
from the list (even the
protected entries).
Note:
The cell phone last connected is then
only connected if no protected device is
in front of this device in the device list.
is switched on. (See "Bluetooth" on
page 119.)
range, and Bluetooth® is activated.

Searching for cell phones

Note:
Prior to a search, switch on Bluetooth®
on the cell phone to be searched for.
> Call up the device list.
Search Bluetooth phones
> Press the
button.
The search starts.
During the search, any devices found are
displayed and you may cancel the search
by pressing the Stop search
After the search or after you press the
Stop search
, a list of the devices found is
displayed.
button.