Table of Contents
Advertisement
>>>
GENERAL OPERATION
Adjusting the unit holder's position
> Loosen the fastening screws
> D
until the carrier plate
> GB
without using excessive force.
> Move the carrier plate
> F
required position and hold it in this
> I
position.
> Tighten the fastening screws
> PL
sufficiently so that the Navigation
5
device is held securely in place when
the vehicle is in motion.
Mounting the navigation device
> Hang the display on the upper hook of
the mounting bracket
> Move the display downwards, it will
then be mounted by the magnetic
mounting bracket
24
Note:
a
4
The device is woken from the sleep
can be moved
6
mode once the display is mounted.
to the
6
Removing navigation device
and
4
> Remove the display carefully down
from the mounting bracket
> Move the display approx. 45° upwards,
and lift it slightly.
Note:
The device will go into sleep mode when
the display is removed in the switched-
on state.
Switching the Navigation device
on/off (model dependent)
With the ON/OFF switch (I/O)
switch the Navigation device on or off
completely.
With the
button on the upper side of
2
the Navigation device you can switch the
device to sleep mode or switch it from
sleep mode again.
2
For devices without the
button on the
1
underside (model dependent): With the
button you can switch the device off,
2
on or to the sleep mode.
you can
1
1
Advertisement
Table of Contents
