Table of Contents
Advertisement
Single Source Master Windows 2000 BarcoMed C
Windows 2000 BarcoMed C
Note: These instructions apply to both Windows
®
Windows
Preparation
Prior to installing your C
be done.
1. Install the BarcoMed C
system.
2. Connect the C
BarcoMed C
3. Decide if you want to install the Barco DPMS Screen Saver
and the Barco I-Switch NioWatch Software in addition to the
driver. (See "Barco DPMS Screen Saver" on page 99 and
"Barco I-Switch Software" on page 63 for descriptions of
these add-on features.)
4. Decide if you are going to install the BarcoMed C
with DualView enabled or disabled) (see Step "7." on
page 59 for a description of DualView).
5. Decide which Palette Mode you wish to use with the
BarcoMed C
the default setting as this setting can be changed later using
the BarcoMed Driver Tab of the Windows Display Properties
control panel.
6. Decide if you want to enable the DirectDraw capabilities of
the BarcoMed C
use the default setting as this setting can be changed latter
using the BarcoMed Driver Tab of the Windows Display
Properties control panel.
7. Decide if you want to disable the 10-bit grayscale
capabilities of the BarcoMed C
are uncertain, use the default setting as this setting can be
ORONIS
XP.
ORONIS
ORONIS
1MP display panel(s) to the
ORONIS
display controller(s) and power supply(s).
ORONIS
display controller. If you are uncertain, use
ORONIS
display controller. If you are uncertain,
ORONIS
software installation
ORONIS
software installation
1MP software the following should
display controller(s) in your
display controller. If you
ORONIS
®
2000 and
driver
ORONIS
53
Advertisement
Table of Contents
Troubleshooting
