Table of Contents
Advertisement
Single Source Master Windows 2000 BarcoMed C
software installation
ORONIS
Figure 31
When the Driver Install Wizard tells you that it has
successfully installed the selected driver, click "Finish".
The wizard will now begin installing the next selected piece
of BarcoMed Software. If you are working with the default
selections, this will be the Barco NioWatch. If you are
working with the default selections, this will be the Barco
DPMS Screen Saver. Please turn to the section, "BarcoMed
NioWatch installationBarco DPMS Screen Saver
installation" below.
If the installation of the products you selected at the
beginning is complete, click "Finish" to exit the BarcoMed
Product Install Wizard or click "Back" to return to the
Welcome Screen of the BarcoMed Product Install Wizard to
select additional software to install. When you click "Finish"
Windows may prompt you to restart your system, if it does
click "Yes". When your system restarts, boot normally and
log in using an account with administrator privileges and
turn to the section "Barco monitor plug and play
software" on page 68.
Note: Clicking "Cancel" will also return you to the BarcoMed
Product Install Wizard, but will not delete the Barco display
63
Advertisement
Table of Contents
Troubleshooting
