Table of Contents
Advertisement
Driver re-installation, updates or removal
7. If you installed your driver with DualView enabled, skip to
step 8.
If you installed your driver with DualView disabledCloned
Heads active, click "Next" to continue. Then click "Finish"
to complete the uninstall process. Click "Finish" again to
exit the wizard. Click "Yes" if Windows tells you that "you
must restart your computer before the new setting will take
effect".
8. If you have installed your driver in DualView mode the
wizard will warn you that you must first disable DualView by
rebooting and then run the uninstall program again.
Click "OK" to continue.
9. Click "Reboot" to disable DualView, click "Finish" to exit
the wizard and then click "Yes" to reboot your system.
10. When your system restarts, log in again using an account
with administrator priveleges. DualView should now be
disabled.
11. The "BarcoMed Product Installation Wizard" should
automatically restart. Finish uninstalling the driver by
clicking "Next" three times. Then click "Reboot", "Finish"
and "Yes".
If the "BarcoMed Product Installation Wizard" doesn't
automatically restart, finish uninstalling the driver by
restarting the "BarcoMed Product Installation Wizard" by
browsing the contents of your Coronis 1MP Software CD and
double clicking on the file: "Setup.exe". Then follow Step 3
on page 164 through Step 7 on page 166 to finish
uninstalling the driver.
166
Figure 60
Single Source Master
Advertisement
Table of Contents
Troubleshooting
