Installing The Barcomed 3Mp2Fh, 2Mp2Fh Or 1Mp2Fh Windows 2000 Software; Using The Barcomed Product Installation Wizard - Barco CORONIS 1MP System Manual

Installing the BarcoMed 3MP2FH, 2MP2FH or
1MP2FH Windows 2000 Software

Using the BarcoMed Product Installation Wizard

SPECIAL NOTE: Prior to installing the BarcoMed drivers and related
software you MUST install the BarcoMed Display Controller(s),
connect the CORONIS display panel(s) to the card(s), and turn the
CORONIS display panel(s) on. Refer to the Hardware Installation
section of this manual for instructions on installing the BarcoMed
Display Controller(s) and connecting them to the CORONIS display
panel(s).
The following software installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
monitor during the Windows 2000 installation process.
To install your BarcoMed 3MP2FH. 2MP2FH or 1MP2FH Windows
Display Controller Driver, BARCO DPMS Screen Saver and
CORONIS Rotation Service for the first time follow the steps below. If
you are reinstalling the drivers or installing a new driver release over
an existing driver release skip to the step 5 on the next page:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the hardware installation section of this manual for
more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each BarcoMed Display Controller you have installed, Windows
2000 will automatically launch the "Found New Hardware Wizard"
(see figure 27 on the next page). Click "Cancel" to exit the "Found
New Hardware Wizard". Continue to click "Cancel" until Windows
2000 stops launching the "Found New Hardware Wizard - Video
Controller".
System manual Coronis 1MP
BarcoMed software driver installation
rd party VGA card and VGA
76