Barco Coronis 1MP Installation & User Manual page 32

Notes:
• The video inputs cannot be connected in loop-through
(daisy-chain).
• The required video amplitude: 700 mV ± 3 dB.
• The required sync. amplitude:
• VS input: 700 mV to 4 V
• HS/CS input: 500 mV to 4V
• Video input (sync on video): 150 mV to 600 mV
To connect analog video & sync cables on D15:
1. Connect one end of the VGA cable to the D15 input (6) of the
display.
2. Connect the other end of the VGA cable to the video output
of your computer.
3. Route the cable so that it enters the connector compartment
at the place where the cover is bulged.
To connect the power:
Connect to DC input
of the display
1. Connect the output of the 12V DC power supply to the DC
input (12) of the display.
2. Connect one end of the proper power cable to the AC input
of the 12V DC power supply.
Connect one end of
power cable
Figure 10
Installation
33