Barco Coronis 1MP Installation & User Manual page 157

Setting the resolution of your C
In order to set the resolution of your C
must be logged in using an account with administrator privileges.
1. To set the resolution of your Coronis 1MP display(s) right click
on the desktop and select "Properties".
2. Select the "Settings" tab.
3. Select the rectangle that represents the first C
display attached to the BarcoMed C
you are working with.
NOTE: If you are using the VGA capabilities of your
BarcoMed C
first display may be set to a VGA resolution of "640 x 480"
pixels with 16 colors and a default refresh rate. If your
BarcoMed C
may not be enabled yet. To enable the display, check the
"Extend my Windows desktop onto this monitor" checkbox,
but do NOT click the "Apply" button at this time.
If you installed your BarcoMed C
mode (default for Windows 2000) there will be one
rectangle for the virtual display representing the two heads
controlled by each BarcoMed C
If you installed your BarcoMed C
mode (default for Windows XP) there will be a rectangle
representing each head controlled by each BarcoMed C
display controller. This will be true even if you have only one
display connected to your BarcoMed C
displays of a display controller cannot be enabled at the
same time unless their display properties match. If necessary
detach the second display of the BarcoMed C
controller you are working with by right clicking on the
rectangle that represents it, deselect "Attached" and click
the "Apply" button.
Tip: Since Windows 2000 and Windows XP will not let you
detach the primary display connected to a particular
158
ORONIS
display controller, the resolution for the
ORONIS
controller is not running VGA, the display
ORONIS
Single Source Master
1MP display
1MP display you
ORONIS
display controller
ORONIS
drivers in SingleView
ORONIS
display controller.
ORONIS
drivers in DualView
ORONIS
controller. Both
ORONIS
ORONIS
1MP
ORONIS
ORONIS
display