Windows NT 4.0 BarcoMed C
Welcome Screen of the BarcoMed Product Install Wizard to
select additional software to install.
When you click "Finish" Windows may prompt you to restart
your system, if it does click "Yes".
Note: Clicking "Cancel" will also return you to the BarcoMed
Product Install Wizard, but will not delete the Barco Display
Driver. The wizard will also begin to install the next selected
piece of BarcoMed Software.
If the Wizard failed to successfully install the selected driver,
it will warn you that the installation failed. Click "Finish" to
return to the BarcoMed Product Install Wizard. The wizard
will now begin installing the next selected piece of
BarcoMed Software. Click "Cancel", then click "Yes" then
click "Finish". Now click "Back" and try reinstalling the
driver following the steps above or using the steps outlined
in "Reinstalling or Updating your BarcoMed Drivers" section
found later in this chapter.
BARCO DPMS Screen Saver installation
8. Click "Next" on the Welcome Screen of the BARCO DPMS
InstallShied Wizard to begin the installation. Click "Cancel"
to cancel the DPMS installation and return to the BarcoMed
Product Install Wizard (figure 19 on page 47).
46
software installation
ORONIS