Barco Coronis 1MP Installation & User Manual page 23

Overview
Autoscan
When you connect a video signal, the display checks in the
internal memory if the signal has been adjusted before. If so, it
selects the settings and parameters that match the connected
signal.
When you connect a video signal that hasn't been connected
before, and adjust the display to the signal, the adjustments and
signal timing parameters are stored in a programmable preset.
Best resolution
The optimum and recommended resolution is 1280 x 1024 or
1024 x 1280 (if the Portrait Accelerator option is installed).
The recommended refresh rate is 60 Hz.
Would you have trouble selecting a proper display setting in
Windows, please refer to the Troubleshooting section further.
BARCO's BarcoMed Coronis imaging board is the best choice to
drive the MFGD 1318 display.
Power saving (DPMS)
The MFGD 1318 is equipped with a power saving system.
When left idle for a certain time, the computer connected to the
display, will power down the display. The power saving system
can be switched on or off using the on-screen menus.
This system requires a computer imaging board that supports
power saving management.
Ambient Light Compensation (ALC)
When enabled, the ALC system automatically adapts the display
light output, depending on the ambient light in the room. The
ambient light is measured by the ALC optical sensor located at
the front of the display.
24