Table of Contents
Advertisement
Introduction
Wallboard Devices
Ferrograph Wallboards 10 and 22
The Wallboard 10 is a single line display consisting of 10 tri-color characters.
The Wallboard 22 is a two line by 22-character tri-color Wallboard.
Both wallboards are connected, via a multi-drop circuits, to the host PC running the
Wallboard Server application.
Specifications
Ferrograph Wallboard 10
Voltage
Wattage
Cold Start
Inrush Current
Baud Rate
Input
Weight
Dimensions
Installation power distribution circuit rating to be greater than 6 amp. Any circuit
breakers must be capable of handling the cold start inrush current without tripping.
For details of Ferrograph Wallboard installation see page 49.
Spectrum 4120C Wallboard
The Spectrum 4120C is a two line 20-character tri-color wallboard. It is connected via a
multi-drop circuit to the host PC running the Wallboard Server application.
Specifications
Voltage
Wattage
Baud Rate
Input
Weight
Dimensions
Spectrum Wallboards can be 'daisy-chained'; this will required the use of the Spectrum
Remote Controller to enable serial addressing. For this and the Wallboard
specifications, safety statements, wall mounting instructions, etc., refer to the
documentation supplied with the Wallboard.
Caution:
Compact Contact Center Installation Manual
40DHB0002USBG Issue 4a (05/29/2003)
Check label on rear of
wallboard
35W
30A for up to 6ms
9600 only
RS 485
4 kg
L 469 x D 75 x H 123 mm Dimensions
Connection to the PC must only be made via the Wallboard's RS485
socket.
System Specifications - Page 13
Ferrograph Wallboard 22
Voltage
220/240V AC OR 110V AC.
(Check label on rear of wallboard)
Wattage
108W
Cold Start
30A for up to 6ms
Inrush Current
Baud Rate
9600 only
Input
RS 485
Weight
6 kg
L 1097 x D 75 x H 198 mm
Check label on rear of wallboard
150W
9600 only
RS 485
8.4 kg
L 1021 x D 129 x H 196 mm
System Specifications - Page 13
Introduction
Advertisement
Table of Contents
