Wall Mounting - Avaya Compact Contact Center Installation Manual

Page 50 - Ferrograph Wallboard 22

Wall Mounting

Once a location has been decided upon, mark its location on the wall with a pencil
through the two holes in the brackets. Before drilling the holes, a suitable utility
detector should be used. Once this has been done, the holes may be drilled and the
brackets mounted using the relevant fixings provided.
Before mounting the display onto the brackets, the network address should be
assigned. The power lead should also be attached prior to mounting.
To mount the display, first hook the bottom of the two brackets into the bottom rear
recess channel of the display. See the diagram shown below.
Push the wallboard flat against the wall and push upwards to fully locate the bottom
half into the recess. Now allow the display to fall approximately one inch. The display
should now be safely located onto the two brackets.
To remove a wall mounted display then reverse the above paragraph.
Note: The wallboard position can be adjusted by sliding sideways in either direction.
Ceiling Mounting
Using the mounting kit provided, firstly, drill the 6-mm holes for the eyehole bolts and
secure them into the ceiling. Pass the spun wire chain through the eyeholes and
through the housing clamps and tighten at the required height.
Remove the right hand end cheek of the wallboard by unscrewing the two fixing
screws.
Slide the two nipples on the end of the spun wire chain into the middle groove of the
display housing and replace the end cheek. Center the display on the hanging wires.
Adjustments can be made by sliding the display to achieve the final level.
Ensure the ceiling can support the weight of the wallboard prior to fixing.
Page 50 - Ferrograph Wallboard 22
Wallboard Installation & Maintenance
Wallboard Installation & Maintenance
WARNING
Compact Contact Center Installation Manual
40DHB0002USBG Issue 4a (05/29/2003)