Table of Contents
Advertisement
Wallboard Installation & Maintenance
Ferrograph Wallboard 10
Introduction
The Wallboard 10 is a single line display consisting of 10 tri-color characters. It
connects via a multi-drop circuit to the host PC running the Wallboard Server
application.
The display wallboard consists of the following assemblies.
Housing: A housing, which is manufactured from an aluminum extrusion with anti
reflective polycarbonate screen and removable aluminum end, caps.
Power Supply: This display has an in-built DC power. This power supply has been set
to the required AC voltage for the country of use.
Logic Control Board: Logic control board that receives RS485 serial data from the
data RJ45 connector.
Installation
The display is supplied with 2 wall mounting brackets, ceiling mounting kit, PC
connection plugs and wall fixings.
The Wallboard 10 displays all come with a 2-metre power cable provided for mains
supply. Ensure the voltage requirement is compatible with the intended mains supply,
and that the supply rating is greater than 5 Amp.
There are two methods of hanging the displays.
Wall Mounting
Fix the 2 wall mounting brackets using the cavity fixings provided. The bracket is
angled to allow a 10 degree downward tilt to the display. Please ensure the brackets
are the correct way up. See the diagram below.
To mount the display, first hook the bottom of the two wall brackets into the bottom rear
channel recess of the display. See the diagram below.
Push display flat against the wall and upwards to fully locate the bottom half of the
bracket. Allow display to then drop down onto the top edge of the 2 brackets to obtain a
locked fixing. To remove, reverse the above procedure.
Note: The display can be adjusted by sliding sideways in both directions.
Compact Contact Center Installation Manual
40DHB0002USBG Issue 4a (05/29/2003)
Ferrograph Wallboard 10 - Page 57
Ferrograph Wallboard 10 - Page 57
Wallboard Installation & Maintenance
Advertisement
Table of Contents
