Table of Contents
Advertisement
Page 20 - Server PC Setup – NT4
Advantech PCI Wallboard Card
Card settings: SW1 (CH1) = ON
To change the settings (NT systems):
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. At set-up complete screen and click Finish.
11. At Advantech PCI serial Service Manager screen make sure that the Start/Stop
12. Click OK at the next screen.
13. Shut down the computer and install the card into PCI SLOT 4.
To change the settings (Win2000 systems):
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. At Advantech PCI serial Service Manager screen make sure that the Start/Stop
11. Click OK at the next screen.
12. Shut down the computer and install the card into PCI SLOT 4.
If applicable (Server and Client on different PCs), you must now configure the Client
PCs (see pages 24, 25, 25 and 26 as appropriate). Alternatively, where Server and
Client are on the same PC, you may now install the appropriate CCC licenses and
applications (see pages 44 and 27 respectively).
Page 20 - Server PC Setup – NT4
PC Configuration
SW1 (CH2) = ON
JP1
JP2
Ensure that the card is not plugged into the PC. If the card is still in the PC shut
down the PC and remove the power leads before removing the card, otherwise the
hard drive may become corrupted.
Insert the Advantech PCI drivers utility installation diskette 1 into drive A.
Select Start, and then click on Run.
At the next screen type A:\setup.exe and click on OK.
At the welcome screen click Next.
At the software license screen agreement screen click Yes.
At the destination screen accept the defaults and click Next.
At program folder accept the defaults and click Next.
When prompted insert disk 2 and click on the OK button.
service control is Install and Start Service and then click OK.
Ensure that the card is not plugged into the PC. If the card is still in the PC shut
down the PC and remove the power leads before removing the card, otherwise the
hard drive may become corrupted.
Insert the CCC CD, do not let it auto run but simply open the CD
Locate and open the folders PRIRS485 card drivers for WIN2K/ICOM_DRV and
click on SETUP.EXE.
At the welcome screen click Next.
At the software license screen agreement screen click Yes.
At the destination screen accept the defaults and click Next.
At program folder accept the defaults and click Next.
When prompted insert disk 2 and click on the OK button.
At set-up complete screen and click Finish.
service control is Install and Start Service and then click OK.
= 485
= 485
Compact Contact Center Installation Manual
40DHB0002USBG Issue 4a (05/29/2003)
PC Configuration
Advertisement
Table of Contents
