Trane IntelliPak Signature Series Programming Manual page 6

®
Table P-GI-1. IntelliPak Points List.
Unit Module Analog Inputs
RTM ASE damper min pos
SCM Evap temp sensor
Sat cond temp sensor
MCM Evap temp sensor
Sat cond temp sensor
Heat Module MWU temp sensor
ECEM Return air temp sensor
Return air humidity sensor
VOM N/A
GBAS 4 inputs from these choices:
Occ zone cool setpt
Occ zone heat setpt
Unocc zone cooling setpt
Unocc zone heat set
Min O/A flow setpt
Sup air cooling setpt
Sup air heating setpt
Sup air static pres setpt
6
Programming
Analog Outputs Binary Inputs
O/A damper actuator Emergency stop
External auto/stop
Unoccupied/occupied
Dirty filter
VAV changeover
Supply airflow proof
Cond fan speed Low pressure control
(Low ambient) Compressor proving
Cond fan speed Low pressure control - ckt 1 & 2
(Low ambient - ckt 1 & 2) Compressor proving - ckt 1 & 2
Modulating heat actuator Low entering air
N/A VOM mode A, B, C, D, E contacts
N/A Demand limit contacts
General
Information
Binary Outputs
VAV box drive max
CV unoccupied mode indicator
Alarm
Fan run request
Water pump request
Compressor relay
Condenser fan A, B
Compressor relay
Condenser fan 1A, 1B, 2A, 2B
Heat 1 relay
Heat 2 relay
Heat 3 relay
VOM relay
Dirty filter
Refrigeration fail relay
Heat fail relay
Fan fail relay
TBD relay
PKG-SVP01B-EN