Toshiba Strata CIX Programming Manual page 35

Table 1-14 Programs 200~202 (continued)
Button Sequence
200-41 Activate Message
Waiting
FB41 Hold
, n,
200-42 Tenant Number
FB42 Hold Hold
, n, ,
201 Station Delete
201 Hold
,
201-01 Primary DN
FB01 Hold Hold
, n, ,
202
ISDN BRI Station
202 Hold
,
202-00 Primary DN
Hold
n, .
202-01 Equipment
FB01 Hold
, xxyyzz,
202-02 ISDN Channel Group
FB02 Hold
, n,
202-03 ISDN Protocol
FB03 Hold
, n,
202-04 Type Connection
FB04 Hold
, n,
Strata CIX/CTX Telephone Button Programming 11/04
Value(s)
n = 1. Enable
2. Disable
n = 1. 1~8. (Default = 1)
n = Up to 5 digits
xx = Cabinet 1 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
yy = Slot 01~8 (CTX100),
01~10 (CTX670)
zz = Circuit (01~04)
n = 1~32 (CTX100)
1~48 (CTX670 Basic)
1~128 (CTX670 Exp.)
n = 1. National ISDN
2. ETSI
3. TTC
4. National ISDN - Nortel
n = 1. Point to Point
2. Point to Multi Point
Telephone Button Programming
Summary
This feature is available only with CTX Release 1.3 or higher software
and with CTX WinAdmin Release 1.3 or higher software.
Enable: This station is allowed to activate station-to-station message
waiting on other stations by dialing the other station number plus 7, 8
or 9; or, by pressing the Msg key. This feature is available with Strata
CTX R1.3 software.
Disable: This station cannot activate station-to-station message
waiting on other stations by dialing the station number plus 7, 8 or 9.
Notes
•
When disabled, digital telephones are still allowed to activate
station-to-station message waiting by pressing the Msg button.
•
This parameter does not apply to Voice Mail ports to use the
special Message Waiting access codes.
Enter the Tenant number to which this PDN should be assigned.
This command deletes stations.
PDN or PhDN to be deleted.
This command assigns ISDN BRI Stations.
ISDN BRI circuit Prime Directory Number.
Enter the BRI equipment number assigned to this PDN. This is the
cabinet, slot, and circuit number of the RBUU/RBUS or RBSU/RBSS
interface PCB to which the the PDN is, or should be, assigned. Enter
data as xxyyzz:
Example: If the PDN should be a assigned to a BDKU in cabinet 5,
slot 2, circuit 3; enter 050203.
Cabinet numbers:
•
CTX100: Select 01 for Base and Expansion cabinet.
•
CTX670: Select 01 for Base and 02~07 respectively for each
Expansion cabinet.
Slot numbers:
•
CTX100: Select 01~04 for Base slots and 05~08 for Expansion
slots.
•
CTX670: Select 01~08 for Base slots and 01~10 for Expansion
slots.
Channel Group Number.
Protocol
Connection format
200 Series Programs
1-31