Toshiba Strata CIX Programming Manual page 23

Table 1-5 Programs 103~107 (continued)
Button Sequence
105-06 Credit Card Code
FB06 Hold Hold
, n, ,
105-07 Credit Card Digits
FB07 Hold Hold
, n, ,
105-08 E911 Service
FB08 Hold Hold
, n, ,
105-09 DR Override by SSD
FB09 Hold Hold
, n, ,
105-10 Auto Station Release
FB10 Hold Hold
, n, ,
105-11 ISDN SPID
FB11 Hold Hold
, n, ,
105-12 Night Mode Relay
FB12 Hold Hold
, n, ,
105-13 BGM External Paging
FB13 Hold Hold
, n, ,
105-14 Lost Call Destination
FB14 Hold Hold
, n, ,
105-15 COS Override Code
FB15 Hold Hold
, n, ,
105-16 Multi-Conference
FB16 Hold Hold
, n, ,
105-17 Caller Number
Display
FB17 Hold Hold
, n, ,
Strata CIX/CTX Telephone Button Programming 11/04
Value(s)
n = Up to 32 digits
n = 1~66 digits
n = 1. Enable (default)
2. Disable
n = 1. Enable (default)
2. Disable
n = 1. Enable (default)
2. Disable
n = 1. Operable
2. Not Operable (default)
n = 0~8
n = 0~4 (CTX100)
0~8 (CTX670 Basic)
0~16 (CTX100 Expanded)
n = Up to 5 digits
n = 1~8
(default = 1)
n = 1. Enable
2. Disable (default)
n = 1. Enable (default)
2. Disable
Telephone Button Programming
Summary
Enter the number dialed to initiate a Credit Card Call. This is normally
ì0î in the USA.
Minimum Dial Digits required for Credit Card Calling. This should be
the quantity of digits in a credit card number. If this quantity of digits is
not dialed when making credit card calls, the caller will be
disconnected. This is to insure that the call is charged to a credit card.
DRL tables in Program 111 and OLGs in Program 306 must be
enabled with credit card calling for this feature to be active. Users
must be assigned to a DRL table enable with credit card calling and
call out on a credit card calling enabled OLG for this featured to be
applied to the call.
Offer of E911 Service.
Destination Restriction Override by System Speed Dial.
Automatic Station Release.
Operation when Auto SPID or User Entry Of SPID fails.
Assign BIOU Relay (1~8) as the Night Relay - this relay activates
when the
system is in the Night Mode.
BIUO1 provides relays 1 to 4.
BIUO2 provides relays 5 to 8
Note The CTX100 ACTU built-in relay is programmed as relay 5.
For this relay operation, a virtual BIOU2 is installed, as
default, in a virtual equipment position - Cabinet 2 slot 5.
(Cab. 02 slot 05, PCB code 20, in program 100). To install an
actual BIOU2 and disable the ACTU built-in relay, use the
programming telephone. To remove the virtual BIOU2 and
then install the actual BIOU2 in Cab. 01/slot 01~08 in the
normal manner.
Set the External Page Group Number that includes the external
paging zones to which BGM will be sent. See PRG503.
Set Lost Call Destination.
Class of Service Override Code Digits.
Conference connection of many member for Analog Internal Call and
Outgoing Call.
Caller number display preferentially.
100 Series Programs
1-19