Dip Switch Settings - Allied Telesis AT-2700FX Installation Manual

Appendix C: Optional BootPROM Chip and DIP Switch Settings

DIP Switch Settings

202
Some older models of the AT-2450FTX, AT-2700FTX, and AT-2745FX
Series cards have a DIP switch you need to set if you install the optional
BootPROM chip. If your network adapter card has the switch, you must set
it to reflect the active port or speed of the adapter. The possible settings
are given in the following tables.
Table 17. AT-2450FTX and AT-2700FTX Series
Active Port
Twisted Pair
Fiber
a. Factory default.
Active Port
100Base-FX Fiber
10Base-FL Fiber
a. Factory default.
Note
If the optional BootPROM chip is NOT installed, the DIP switch
should be set to the factory default setting.
Switch Position
a
Up
Down
Table 18. AT-2745FX Series
Switch Position
a
Up
Down