Settings Option; Speed/Duplex Selection; Default Port - Allied Telesis AT-2700FX Installation Manual

Chapter 10: AT-Diag Utility

Settings Option

Speed/Duplex
Selection

Default Port

184
The Settings menu option is used to do the following:
Set the speed and duplex mode of an adapter port
Specify the default port for the MBA on a dual port adapter
Enable or disable the BootPROM chip and the MBA
Selecting this menu item displays the EEPROM Settings menu, shown in
Figure 113.
Figure 113. EEPROM Settings Menu
The menu selections are described in the following sections.
This selection sets the speed and duplex mode of a port. The selections
vary depending on the port type. For example, a fiber optic port has
settings only for duplex mode since a fiber optic port has a fixed operating
speed.
Selecting the menu item displays a list of possible speed and duplex mode
settings. To select a setting, type the corresponding number from the
menu or use the up and down arrow keys to highlight the selection and
press Return.
If you are configuring a dual port adapter, Allied Telesyn recommends
connecting the appropriate port to the network before setting this
parameter. The remote device, such as an Ethernet hub or switch, to
which the port on the adapter is connected should be active and
functioning properly.
This selection applies only to dual port adapters and is used to designate
the port where MBA is to be active. MBA can be active on only one port at
a time and it cannot change ports automatically. You must designate the
port on dual port adapters manually using this menu selection. If you
intend to use MBA, the default port must be the port connected to the
network.
Selecting the menu item displays a list of the adapter's two ports. Select a
port by typing the corresponding number from the menu or using the up
and down arrow keys to highlight the selection and pressing Return.
EEPROM Settings
Speed / Duplex
Default Port
BootROM