Allied Telesis AT-2700FX Installation Manual page 55

Note
If you installed a dual port network adapter card, connect only one
port to the network.
11. Power ON the system.
If you installed the adapter card in a Microsoft Windows 2000, 2003, or
XP system and did not pre-install the driver, the Found New Hardware
Wizard launches automatically once the system detects the new card.
Figure 10 illustrates the first window of the wizard.
Figure 10. Found New Hardware Wizard Window
12. At this point, you have a choice on how to install the adapter card's
driver. If you prefer to use the AT-Setup utility, click Cancel in the
wizard and perform the procedure "Installing or Updating a Driver
Using the AT-Setup Utility" on page 59. Alternatively, you can use the
wizard to manually install the driver by performing the procedure
"Manually Installing a Driver" on page 73.
This completes the installation of the network adapter card. Go to the
appropriate chapter in this guide for installation instructions for the
adapter card's driver.
Network Adapter Card Installation Guide
55