Allied Telesis AT-2700FX Installation Manual page 93

Note
The Network Connections window will contain more than one LAN
connection if the system contains more than one adapter or if VIDs
were added to an adapter using the AT-MUX protocol.
2. Do one of the following:
If you are not using the AT-MUX protocol, right-click the Local
Area Connections of the LAN connection icon for the network
adapter card and then select Properties, as shown in Figure 53.
The LAN connection icon for the network adapter card has the
adapter card model number in the icon's label. (To view an icon's
label, select the Tile menu selection under the View menu in the
Network Connections window. Alternately, you can open the
Properties window of a LAN connection.)
Figure 53. Local Area Connections Pop-up Menu
If you are using the AT-MUX protocol, right-click the Local Area
Connections of the LAN connection icon for the VLAN you want to
configure and then select Properties. The IP information on a
system using the AT-MUX protocol must be set on each VLAN
individually, and not on the adapter. For further information on the
protocol, refer to Chapter 9, "AT-MUX Multiple VLAN Protocol" on
page 157.
Network Adapter Card Installation Guide
93