Installing The Driver On A Microsoft Windows Nt 4.0 System - Allied Telesis AT-2700FX Installation Manual

Chapter 4: Microsoft Windows NT 4.0

Installing the Driver on a Microsoft Windows NT 4.0 System

108
The following procedure installs the network adapter driver on a Microsoft
Windows NT 4.0 operating system. You can perform the procedure using
the Allied Telesyn Installation CD or, for those systems without a CD drive,
a driver installation diskette. For instructions on how to create a driver
installation diskette, refer to "Creating a Driver Installation Disk" on
page 68.
Note
Allied Telesyn recommends installing Service Pack 6a (SP6a) on a
Windows NT 4.0 system before installing the network adapter driver.
To install the network adapter driver, perform the following procedure:
1. Shutdown Windows NT and power OFF the system.
2. Install the network adapter card. Refer to Chapter 2, "Installing a
Network Adapter Card" on page 45 and the documentation that came
with your system for instructions.
3. Power ON the system.
4. From the desktop, click Start.
5. Select Settings, then select Control Panel, as shown in Figure 62.
Figure 62. Start Menu