Table of Contents
Advertisement
Chapter 7: Port Parameters
Displaying Port Settings
Displaying Speed
and Duplex
Settings
Port
port1.0.18
port1.0.20
Displaying Port
Status
158
There are several ways to display port settings. See the following:
"Displaying Speed and Duplex Settings" on page 158
"Displaying Port Status" on page 158
"Displaying Port Configuration" on page 159
To display the speed and duplex mode settings of the ports, use the
SHOW INTERFACE STATUS command in the Privileged Exec mode.
Here is the format:
show interface [
This example of the command displays the speed and duplex mode
settings for ports 18 and 20:
awplus# show interface port1.0.18,port1.0.20 status
Here is an example of the information the command displays.
Name
Status
Port_01
down
Port_02
up
Figure 37. SHOW INTERFACE STATUS Command
The columns are described in Table 11 on page 193. For a description of
the command, see "SHOW INTERFACE STATUS" on page 193.
To display the current status of the ports on the switch, use the SHOW
INTERFACE command in the Privileged Exec mode. Here is the format:
show interface
This example displays the settings for ports 1 and 2:
awplus# show interface port1.0.1,port1.0.2
port
] status
Vlan
Duplex
3
half
11
auto
[port]
Speed Type
100
10/100/1000Base-T
auto
10/100/1000Base-T
Section II: Basic Operations
Advertisement
Table of Contents
