System Status Leds; Figure 16. System Status Leds; Table 6. System Status Leds - Allied Telesis x600-48Ts Installation Manual

Chapter 1: Overview

System STATUS LEDs

36
The system status LEDs on the front panel display general status
information. To locate these LEDs, see Figure 16.

Figure 16. System STATUS LEDs

See Table 6 for a description of the System STATUS LEDs.

Table 6. System STATUS LEDs

LED State
FAULT Off
Red
Off
Flashing
MASTER
Green
Solid
Green
RPS Off
Solid
Green
POWER Off
Solid
Green
STATUS
FAULT
MASTER
RPS
RESET
PWR
1622
Description
Indicates normal operation.
Indicates a fault. The switch or the operating
system software has malfunctioned. (Refer to
Chapter 5, "Troubleshooting" on page 91 for
instructions on how to troubleshoot a problem.)
Indicates that the switch is not the STACK
Master.
Indicates the specific stack member's ID of the
switch in response to the SHOW STACK
INDICATOR command. The LED will repeatedly
flash n times in quick succession, followed by a
longer pause, where n is the stack member's ID.
Indicates that the switch is the STACK Master.
No optional redundant power supply is
connected to the switch.
An optional redundant power supply is physically
connected to the switch and may be powered on
or off.
The switch is not receiving power.
The switch is receiving power.