Installing The At-Stackxg Module; Figure 35. Removing The Blank Panel From The Expansion Slot - Allied Telesis x600-48Ts Installation Manual

Installing the
To install the AT-StackXG module, perform the following procedure:
AT-StackXG
1. Remove the module from the shipping package.
Module
2. Remove the blank panel from the expansion slot on the rear panel of
3. Align the edges of AT-StackXG module with the guides in the slot and
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
the switch by loosening the two captive screws on the panel with a
cross-head screwdriver.
A T - L X
4 4 C P
U C V R

Figure 35. Removing the Blank Panel from the Expansion Slot

Note
All X600 Series Layer 3 Switch models are shipped from the factory
with a Blank Panel installed in the rear panel Expansion Slot except
for the x600-48Ts/XP, which is shipped with an AT-LBM (Loop Back)
module instead.
Note
Do not remove the blank panel from the chassis until you are ready
to install a module. An open slot allows dust to enter the unit and
reduces proper airflow and cooling.
carefully slide the module into the chassis until it is flush with the rear
panel of the chassis, as shown in Figure 36 on page 74. Light pressure
may be needed to seat the module on the connector on the rear panel
of the chassis.
x600 Layer 3 Gigabit Ethernet Switch Installation Guide
1241
73