Resiliency Link Configurations Via Switch Ports; Figure 25. Resiliency Link Connecting To Switch Ports Over The Resiliencylink Vlan; Figure 26. Resiliency Link Connecting To Switch Ports Over The Resiliencylink Vlan Using A Network Hub - Allied Telesis x600-48Ts Installation Manual

Chapter 2: Virtual Chassis Stacking
Resiliency Link
Configurations
via Switch Ports
54
Two resiliency-link configurations that connect to switch ports are shown
below:Figure 25 shows the resiliency link connecting in a ring topology,
whilst Figure 26 shows the resiliency link connecting to its switch ports via
a network hub. In both configurations, the resiliency link connections are
made using the ResiliencyLink VLAN and attaching the switch ports to the
VLAN. For more information on using the resiliency link commands go to
the Software Reference for the x600 Series Switches which can be found
at www.alliedtelesis.com. The specific commands are the STACK
RESILIENCYLINK command on page 86.27 and the SWITCHPORT
RESILIENCYLINK command on page 86.30.
Stack Resiliency Link -
x600-24Ts
x600-24Ts
Figure 25. Resiliency link connecting to switch ports over the
x600-24Ts
x600-24Ts
Figure 26. Resiliency link connecting to switch ports over the
ResiliencyLink VLAN using a network hub
Connecting to Switch Ports
Stacking Links
ResiliencyLink VLAN
ResiliencyLink VLAN
Network Hub
Resiliency Links
to Switch Ports
Stacking Links
x600-24Ts
x600-24Ts
x600-24Ts
x600-24Ts