System Status Leds; Figure 18. System Status Leds On The Front Panel; Figure 19. System Status Led On The Rear Panel; Table 9. System Status Led Descriptions - Allied Telesis 48Ts/X Installation Manual

System STATUS LEDs

The system STATUS LEDs on the front panel display general status
information. To locate these LEDs, see Figure 18. On the rear panel there
is a single system STATUS LED, as shown in Figure 19. See Table 9 for a
description of the system STATUS LEDs.

Figure 18. System STATUS LEDs on the Front Panel

Figure 19. System STATUS LED on the Rear Panel

Table 9. System STATUS LED Descriptions

LED State
FAULT Off
Solid
Red
MASTER Off
Flashing
Green
Solid
Green
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
STATUS
FAULT
MASTER
RPS
PWR
RPS
READY
Description
Indicates normal operation.
Indicates a fault. The switch or the operating
system software has malfunctioned. (Refer to
Chapter 5, "Troubleshooting" on page 103 for
instructions on how to troubleshoot a problem.)
Indicates that the switch is not the Stack
Master.
Indicates the specific stack member's ID of the
switch in response to the 'show stack indicator'
command. The LED will repeatedly flash 'n'
times in quick succession, followed by a longer
pause, where n is the stack member's ID.
Indicates that the switch is the Stack Master.
41