Stack Member Failure And Recovery - Allied Telesis x600-48Ts Installation Manual

1- L/A
2- L/A
PRES
STATUS LEDs
MASTER
Stack Member
Failure and
Recovery
LED State
Solid
Green
Green
Flashing
Green OFF Link on stacking port 1 is inactive.
Solid
Green
Green
Flashing
OFF
Solid
Green
Solid
Green
Green
Flashing
Running QoS within a VCS stack
In general you can apply the same principles when configuring QoS on a
VCS stack as you would for single switch; however there are a few specific
changes that you will need to make. See the AlliedWare Plus Software
Reference more information on this topic.
Management IP Addresses
A single virtual MAC address, from the current Master, is used as the stack
MAC address. If the stack master fails, the stack MAC address changes to
reflect the new master's MAC address. If the stack MAC address does
change, ARP tables of devices on the network are updated to reflect the
change in MAC address via gratuitous ARP.
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
Description (Continued)
Link on stacking port 1 is active.
Indicates traffic flowing through stacking port 1
Link on stacking port 2 is active.
Indicates traffic flowing through stacking port 2.
Link on stacking port 2 is inactive.
VCS Stacking Module (AT-StackXG) or
Loopback Module (AT-LBM) has been
inserted, i.e. is PRESENT.
The switch is the Stack Master.
When the STACK INDICATOR command is
activated, this LED will flash with a pattern that
indicates the stack member ID of the switch.
59