Table of Contents
Advertisement
Onboard Lan Boot ROM
This item allows you to invoke the boot ROM of the onboard LAN chip.
O
ptions: Disabled (default)、Enabled
U
SB Controller
T
his option should be enabled if your system has a USB port installed on the system board. You will
n
eed to disable this feature if you add a higher performance controller.
O
ptions: All Enabled (default)、All Disabled
O
nChip EHCI Controller
T
his option should be enabled if your system has a USB 2.0 device installed on the system board.
You will n
eed to disable this feature if you install a USB 1.1 device.
O
ptions: Enabled (default)、Disabled
U
SB Device Support
E
nables support for USB attached devices. Options: Disabled (default)、Enabled
Super IO Device
If you highlight the literal "Press Enter" next to the "Super IO
k
ey, it will take you a submenu with the following options:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add
in this field. Options: E
nabled (default)、Disabled
Onboard Serial Port 1
S
elect an address and corresponding interrupt for the first serial port.
Options: Disabled、
3F8/IRQ4 (default)、 2F8/IRQ3、 3E8/IRQ4、 2E8/IRQ3、 Auto
Onboard Serial Port 2
S
elect an address and corresponding interrupt for the second serial port.
Options: Disabled、2F8/I
RQ3 (default)、3F8/IRQ4、3E8/IRQ4、2E8/IRQ3、Auto.
Onboard Parallel Port
This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)、
-in FDC or the system has no floppy drive, select "Disabled"
278/IRQ5、3BC/IRQ7、Disabled
36
KM400A Series
Device" label and then press the enter
Advertisement
Table of Contents
