Equipment Required; Pre-Adjustment Setup - HP 37717C Calibration Manual

C AU T I O N
Performance Tests
Transmitted Jitter/Wander Amplitude Accuracy (Option A3K [A3Q])

Equipment Required

Communications Performance Analyzer : HP 37717C Opt UHN
Spectrum Analyzer
Oscilloscope
Modulation Analyzer
Synthesizer
75 /50 Matching Pad

Pre-Adjustment Setup

Before carrying out any adjustments to the HP 37717C Jitter Transmitter Module,
perform the following pre-adjustment setup.
This procedure uses the special
When using the
MODULE DEBUG
Altering other parameters can damage instrument firmware - exit the
display after setup to prevent accidental damage.
MODULE DEBUG
1. Recall the HP 37717C DEFAULT SETTINGS as shown on 3-2.
2. Setup the HP 37717C
as shown opposite.
: HP 8568B Opt 001
: HP 54503A
: HP 9801A/B
: HP 3325B
: HP 11825B
MODULE DEBUG
display, ONLY modify the parameters shown.
OTHER display
display on the HP 37717C.
3-135