HP 37717C Calibration Manual page 384

Appendix B - Fitting, Calibrating & Testing New
Table B-1
Module Under Test
Unstrucured PDH Tx/
Rx
Structured PDH Tx
Structured PDH Rx
SDH Tx/Rx
Optical Tx/Rx
PDH/SDH Jitter Tx
PDH Jitter Rx
Appendix B - Fitting/Calibrating/Testing New Modules
Modules
Some of the Performance Tests for the HP 37717C require additional modules to be
present in the instrument. Table B-1 lists each module (and option) under test and
the additional modules which must be present to test it.
To decide if you need to fit any modules, compare Table B-1 with the options listed
on the Rear Panel of the instrument under test.
If additional modules are required, follow the procedure below when fitting,
calibrating and testing. Some modules also need to be calibrated after fitting (see
Table B-1). Calibration procedures for these modules are included here.
Additional Modules Required for Performance Tests
Option
Under Test
UKK,
[USB]
special 808
UKJ, [USA]
UKJ,
[USA],
UKL, [USC]
US1, [US5],
A1T, [A1U]
A3R [A3S]
UH1, UH2,
URU, USN,
UKT, 130,
131
UHK, A3K
UHN [US9],
Module(s) Part Number
Required
None
SPDH Rx 37717-60021
SPDH Tx 37717-60020
None
SDH Tx/Rx 37714-60048
PDH Tx 37714-60044*
Jitter Tx PDH 37717-60010
Tx/Rx 37714-60044*
Calibration
Required?
No
No
No
No
No
No
Jitter Tx
B-1