Mb/S - HP 37717C Calibration Manual

Performance Tests
ETSI/ANSI Receiver Monitor Levels (Option 110)

2.048 Mb/s

3. Press
TRANSMIT
display as shown
MAIN SETTINGS
opposite.
4. Press and set up the
RECEIVE
display as shown opposite.
SETTINGS
5. Press
TROUBLE SCAN
RESULTS
Press to start the
RUN/STOP
measurement.
6. Ensure that NO TROUBLE is
displayed on the
RESULTS
7. After 30 seconds. Press
stop the measurement.
8. Press and select EQUALIZATION [ON] GAIN [20 dB].
RECEIVE
9. Connect Cable Simulator #1 between the PDH OUT Port and the Matching Pad.
10. Press
TROUBLE SCAN
RESULTS
measurement.
11. Ensure that NO TROUBLE is displayed on the
seconds. Press
RUN/STOP
12. Connect the second 6dB Fixed Attenuator in the signal path to give a total path
attenuation of 26.8dB (7.6+3+6+6+4.2).
13. Press and set MONITOR LEVEL [26dB].
RECEIVE
14. Press ;
RESULTS
measurement.
15. Ensure that NO TROUBLE is displayed on the
seconds. Press
RUN/STOP
and set up the
MAIN
.
display
to
RUN/STOP
. Press
to stop the measurement.
. Press
TROUBLE SCAN
to stop the measurement.
to start the
RUN/STOP
display after 30
RESULTS
to start the
RUN/STOP
display after 30
RESULTS
3-235