Keypad Operation - Gemini GEM-P801 Installation Instructions Manual

Burglary Zone Wiring
The GEM-P801 provides 6 true hard-wired, End-
Of-Line Resistor terminated burglary zones. Wire
zones as shown in the wiring diagram (pg. 27).
All resistors must be installed, even if the zone is
not used. If required, the feature No End Of Line
Resistor may be programmed, in which case a
direct short across the zone will cause the zone
to set up. (NOTE: Not for UL applications)
Program the zone as a No EOL Resistor Zone
[06].
If necessary, use the voltage chart below to verify
proper voltages. These values represent the DC
voltage of the zone while in the indicated state
with reference to the the zone's respective
ground terminal.
Zone Normal (EOL across zone)
Zone shorted
Zone Open
3 V T
TABLE
OLTAGE AT ERMINALS
Fire Zone Wiring
Wire the Fire Zone as shown in the Wiring
Diagram in the back of this manual. An EOL
resistor must be installed, even if the Fire Zone
is not used.
Fire Zone Normal
Fire Trouble
Fire
TABLE
PGM Wiring
The PGM (Terminal 19) is a switched negative
output that is activated through programming
option(s)
programming blocks [08], [23] - [25], [26-2].
Connect the device controlled by the PGM
2.5 V
between +PWR and the PGM terminal.
(maximum load of 50 mA).
0 V
5 V

Keypad Operation

3&5, 6&8, 9&11
Keypad zone LEDs indicate zone status.
ARMED, STATUS and
provide system status.
provides feedback beeps for correct and
incorrect entries.
4 V F Z
(Terminals 12&13)
OLTAGE AT IRE ONE
that have been selected
SYSTEM LEDs
H
The keypad sounder
Keypad Sounder
3
QUICK BEEPS
Panel Armed (System ON)
Chime ON
Fault Find Mode ON
Keypad Sounder ON
13.0V
Zone Bypassed
13.8V
6
QUICK BEEPS
0.0 V
Panel Disarmed (System OFF)
Chime OFF
Fault Find Mode OFF
Keypad Sounder OFF
Zone Un-Bypassed
in
1 -
SECOND STEADY TONE
Incorrect Code Entered
Invalid key entry
4 (
LONG BEEPS PRIORITY CONDITION
1. Entering an Arm Code with a faulted zone
(Not an Auto-Bypass Reentry Zone).
2. Entering an Arm Code when the Bell or
PGM is ON (Bell and PGM will turn OFF).
3. Arming with the Fire LED ON - reset
required. Press the
)
key.
C
7