Programming The Panel - Gemini GEM-P801 Installation Instructions Manual

Programming the Panel

Refer to GEM-P801 Programming Instructions (WI1090)
Defaulting the Panel
1. Remove power from the panel.
2. Remove all wiring from terminal 19 (PGM) and
terminal 3.
3. Connect terminal 19 (PGM) to terminal 3.
4. Apply power to the GEM-P801 control panel.
5. After a few seconds the ARMED, READY and
SYSTEM TROUBLE LEDs will flash.
H
6. The keypad will beep 3 times indicating the
panel default values have been loaded.
7. Remove wiring between terminal 19 (PGM)
and terminal 3.
8. Re-install original wiring for terminal 19 (PGM)
and terminal 3.
N :
OTE
Any programming in Dealer Options 1 [96] and Dealer
Options 2 [97] will not be defaulted.
Lockout has been programmed the panel will not default
the Dealer Code.
Keypad Programming
Refer to WI1090 for information on keypad
programming.
Downloading
The GEM-P801 panel can be download/uploaded
with PCD-Windows Version 4.1 software using
the Ring Method, Answering Machine Override
(Second Call) or
A6
downloading. The panel
automatically downloaded/uploaded using the
PCPreset utilty. For Site Initiated Downloaded,
see Auto Download ID Number [93].
Local Downloading
Wire as shown in Figure 1. Use the power up or
A6
The power up method is recommended if the panel is
attempting to report.
If Dealer Code
FIGURE
Remote Downloading
Wire as shown in Figure 2. The panel can be
remotely download/uploaded using any one
of the following methods:
1. The
method of
2. Call-in method
can also be
3. Answering Machine Override (Second
method of establishing a connection.
TELCO
JACK
16 17 18 19 20
GND
+PWR
RED
BLACK
*
RED
*
GREEN
PCL2000B
*
Insulate if not used
MODEM
1 L D
OCAL OWNLOAD
method
A6
Call)
4. Site-Initiated (PCPreset &
5. Automatic Downloading (Using PCPreset)
TELCO JACK
GEM-P801 Panel at the site
PCI2000
J3
J1 J2
LOCAL TELCO
TO COMPUTER TO EXTERNAL
TO
MODEM
2 R D
FIGURE
EMOTE OWNLOAD
)
A6
RJ31X
TELCO
J5 LINE
J4
OUT TO
MODEM
5