Table of Contents
Advertisement
(3) Reserved
(4) Reserved
[68]Telephone Number 3
(1) Opening after Alarm (Cancel Code) -
see [67-1].
(2) Conditional Closing Telco 3 - see [67-
1].
(3) Reserved
(4) Reserved
Wireless
Up to two receivers can be wired to the
GEM-P801. Each wireless transmitter can
be mapped to a zone. Only 1 wireless device
is permitted per zone, however, the use of
both hardwired and wireless on a zone is
permitted.
To Map a transmitter to a zone:
1. Enter the Programming Block Number
that the transmitter is to be mapped to.
2. Enter the 7-digit RF ID number directly,
just as it is shown on the device label.
After the 7th digit is entered the keypad
will beep.
A transmitter will send a transmission every
time it is tripped. The transmitter also sends
a supervisory transmission about once every
hour.
If the receiver does not receive a
signal from a transmitter in the time
programmed
in
Wireless
Timer, a system trouble 'RF Supervisory
Failure' will be indicated at the keypad.
Program Wireless Supervisory Timer [16] to
change the supervisory time from the
default of 12 hours.
The Signal strength of a transmitter can be
checked at the keypad (see
Fault Find Mode) or saved to the LOG (see
Signal Strength Logging Mode - pg. 11).
[71-78] Wireless Transmitters
Enter the RF ID# and the point number that
is to be mapped to the zone.
Programming Example
Map point 1 of a window door transmitter
with an RF ID# of 0012B0:0 to Zone 3.
1. Enter Dealer Mode.
(
2. Enter
beeps)
C
73
3. Enter
12G200
Enter
(beeps)
1
Note: If the RF ID# in step 3 is not entered
correctly the keypad will emit a 1 second
tone indicating incorrect entry.
steps 2 - 4 above.
[81] - [84] Wireless Keyfobs
The GEM-KF is a hand held wireless
transmitter
capable
of
Disarming
the
control
Supervisory
activating 2 Auxiliary Functions. To activate
the auxiliary functions, press and hold the
[A1] or [A2] key for 1.5 seconds (see WI752
for more information).
Enter the RF ID# and AUX 1 and AUX 2
options for each Keyfob.
AUX 1 & AUX 2
A7
Programming Options:
1 Panic
Program a 1 in the AUX 1 and/or AUX 2
option to initiate a panic alarm when the [A1]
or [A2] buttons on the Keyfob are pressed.
Additional programming required:
Keypad Panic (
Panic Report to Telco 1[36-2] and/or Telco 3
[56-3].
Audible Panic (Optional) [21-1]
2 AUX
(beeps)
Program a 2 in the AUX 1 and/or AUX 2
option to initiate a AUX alarm when the [A1]
or [A2] buttons on the Keyfob are pressed.
Additional programming required:
Keypad AUX (
Repeat
AUX Report to Telco 1[36-2] and/or Telco 3
[56-2].
3 Bell ON
Program a 3 in the AUX 1 and/or AUX 2
Arming
and
option to turn the Bell ON when the [A1] or
panel
and/or
[A2] buttons on the Keyfob are pressed.
) [20-3]
9G
) [20-2]
8G
19
Hide quick links:
Advertisement
Table of Contents
