Table of Contents
Advertisement
[44]Dialing Prefix
Dialing prefix for Telco 1, Telco 2, and Telco
3. Program if using an Outside access
number.
[45]Communicator Features 1
(1) Communicator Enabled - Program to
enable the communicator.
(2) DTMF with Rotary Backup - The first
attempt to communicate is dialed using the
TouchTone method of dialing, subsequent
attempts are dialed using the pulse method
of dialing. Disable this feature to dial using
only rotary dialing.
(3) DTMF only - All attempts to communicate
dial using the TouchTone method of dialing.
(4) Backup Reporting to Telco 2 - After 2
attempts are made to communicate to Telco
1 the backup phone number is dialed (Telco
2).
[46]Communicator Features 2
(1) No Dial Tone Detection - Program to
disable dial tone detection for Telco 1, Telco
2 and Telco 3.
(2) 2:1 Rotary Dialing - Changes the make
break ratio when rotary dialing from 1.5:1 to
2:1.
(3) Backup if < 4 attempts - If Backup
Reporting [45-4] has been enabled, the
communicator will use Telephone Number 2
[41] for the remaining retries when there are
less than 4 retries remaining.
(4) Don't Clear Fail to Communicate
Program to prevent a good line cut test from
clearing a Failure to Communicate system
trouble. If programmed, only a successful
communication to Central Station will clear
a Failure to Communicate system trouble.
Pager Programming
If Pager Format ([32]and/or[42]and/or[52] =
7) is selected, pager data will be displayed
as shown in Figure 8. If Pager Format is
selected 4/2 format must be programmed
and Sumcheck is not permitted. If a PIN
number is required refer to Leading Digits
[47].
000 033-1234
Leading Digits
Report Code
Subscriber ID Number
8 D
P
D
FIGURE
EFAULT
AGER
Pager Alarm data is the same as 4/2 format
with the exception that the 2 digit Report
Code is transmitted before the 4 digit
Subscriber ID.
N
:
OTE
Digits in Report Codes and subscriber IDs that are
programmed with "B" through "F" will be converted to "0"s.
[47]Leading Digits
Pager PIN Number - If a PIN number is
required by the paging system, program the
PIN number in the Leading Digits location.
See sample program below.
If a 7-digit PIN number is required, program
the panel as follows:
[31]/[41]/[51] - Pager Telephone number
[32]/[42]/[52] - Select Pager Format
[47] -
7-digit PIN Number
Leading and Trailing digits can be letters B, C
or D. B = the * button on a telephone, C =
the # button on a telephone, D = 2 second
delay.
[48]Trailing Digits
Transmitted after alarm data.
section [47] for programming information.
[49]Pager Options
(1) Skip Alarm Data - Once pager format is
ISPLAY
selected, program this option to skip alarm
data.
programmed Leading and Trailing digits are
sent, but the event code and subscriber ID
are not transmitted.
selected, a telephone number programmed
in Leading Digits or Trailing Digits would
send the telephone number to the pager
X X X X X X X C
Terminating Digit (#)
Refer to
If this option is selected, all the
With this option
17
Hide quick links:
Advertisement
Table of Contents
