Connecting A Conference; Adding A Call To The Conference - Mitel Inter-Tel User Manual

3. The Attendant Console copies the call into the Conference Setup list, as shown
below.
NOTE:
connected, the Begin button will be grayed out.
4. Repeat steps 1 and 2 for all calls to be included in the conference.
If you copy the wrong call into the Conference Setup list, remove it by highlight-
ing it in the Conference Setup list and clicking Remove Call. This does not
affect the Call List, only the Conference Setup list.
NOTE:

Connecting a Conference

When you have built your Conference list, you are ready to connect the conference
call.
— Click Begin on the Conference dialog. The Attendant Console removes all
entries from the Conference
Call List, and adds the conference call as a connected call in the Call List.

Adding a Call to the Conference

During a conference, if you want to add a party, do the following:
1. Place the conference on hold by moving it to the Conference Setup dialog, as
described above.
2. Place a call to the party you wish to add and move that call to the Conference
Setup dialog.
3. Click Begin.
90
The call still appears in the Call List. If one of the calls is on hold or not
There is no active conference yet.
Setup list, removes the individual calls from your
®
Inter-Tel Attendant Console User Guide