Quick Start - Meinberg LANTIME/GPS Operating Instructions Manual

Quick Start

- Approximately 30 seconds after power up the lower display line shows "NTP: not
sync" instead of "NTP: not ready".
SERVER NOT READY
NTP: Not Ready
- If the GPS receiver remains asynchronous (FAIL LED is still on after 12 minutes)
the number of satellites in view and the good satellites are to check (press
MENU twice). The antenna has to be installed without any obstructions to the
sky.
- Enter TCP/IP address, netmask and default gateway:
- Press Menu four times to enter the LAN PARAMETERS setup menu
- Press CLR/ACK to see the TCP/IP address first
- Press CLR/ACK once again to be able to enter the IPv4 TCP/IP address
- With NEXT the respective digit is to select while INC is used to set the value
- To take over the changes it is necessary to press CLR/ACK again
- A wildcard '*' is displayed to confirm the changes
- Pressing NEXT, the netmask and the default gateway can be entered in the
same way
- Pressing MENU following by INC causes the changes to become active
NOTE: All settings are related to the first Ethernet connection (ETH0).
After this all further settings can be done via network interface, either by using a
WEB browser or a Telnet Session.
Default user: root
Default password: timeserver
Wed, 18.11.1998
UTC 10:03:30 ==>
SATELLITE CONSTELLATION
In view: 9 Good: 8
SETUP: LAN PARAMETERS
TCP/IP ADDRESS: DHCP 172.16.3.40
Are you sure ?
INC -> YES
8
NORMAL OPERATION
NTP: not sync
Sel: 3 19 26 13
Press ...
MENU -> NO
Wed, 18.11.1998
UTC 10:04:10