Global Option File - Meinberg LANTIME/GPS Operating Instructions Manual

SNMP Write Community String
SNMP Contact String
SNMP Location String
# Windows Messages Section
WMail Address 1
WMail Address 2
# VP100 Display Section
VP100 Display Address 1
VP100 Display Sernum
VP100 Display Address 2
VP100 Display Sernum
# Notification Section
Notification on NTP_not_sync
Notification on NTP_stopped
Notification on Server_boot
Notification on Refclock_not_respon.[CASE]:
Notification on Refclock_not_sync
Notification on Antenna_faulty
Notification on Antenna_reconnect
Notification on Config_changed
Notification on Leap second announ. [CASE]:
# Ethernet Parameter Section
ETH0 IPv4 TCPIP address
ETH0 IPv4 NETMASK
ETH0 DHCP CLIENT
ETH0 IPv6 TCPIP address 1
ETH0 IPv6 TCPIP address 2
ETH0 IPv6 TCPIP address 3
ETH0 IPv6 Autoconf
ETH0 Net Link Mode
ETH0 Bonding Group

Global Option File

This file contains all global options for special hardware configuration of the
LANTIME. Do not modify this file. You can find this file on the write protected flash
disk at /mnt/flash/global_options:
#GLOBAL OPTIONS
NUMBER ETHERNET INTERFACES: 1
SYSTEM LAYOUT: 0
SYSTEM ADV LAYOUT: 0
SYSTEM LANGUAGE: 0
SYSTEM PARAMETER: server
SYSTEM DESIGN: 0
[ASCII,50]:
[ASCII,50]:Meinberg
[ASCII,50]:Germany
[ASCII,50]:
[ASCII,50]:
[ASCII,50]:
1 [ASCII,50]:
[ASCII,50]:
2 [ASCII,50]:
[CASE]:
[CASE]:
[CASE]:
[CASE]:
[CASE]:
[CASE]:
[CASE]:
[BOOL]:1
[BOOL]:1
[NUM,0:4]:
[NUM,0:4]:
136
[IP]:0
[IP]:0
[IP]:
[IP]:
[IP]: