Windows Popup Messages; Snmp-Trap Messages; Vp100/Net Wall Mount Display - Meinberg LANTIME/GPS Operating Instructions Manual

Windows Popup Messages

Most Microsoft Windows operating systems provide you with a local notification
tool. You can send messages via the special Windows protocol in your local network.
It is not necessary to enable the NETBIOS protocol of the LANTIME in order to use
this notification. On the Windows client side it is necessary to activate the "Microsoft
Client for Windows" in the network configuration.
You can enter the Windows computer name of up to two Windows PCs in the
appropriate fields. Every message contains a time stamp and a plain text message:

SNMP-TRAP messages

Up to two SNMP trap receiver hosts can be configured in this subsection, you may
use IPv4 or IPv6 addresses or specify a hostname. Additionally you have to enter a
valid SNMP community string for your trap receiving community. These can be
unrelated to the SNMP community strings used for status monitoring and
configuration access (see SNMP configuration on the "Security" page).

VP100/NET wall mount display

The VP100/NET wall display is an optional accessory for the LANTIME
timeserver, it has an own integrated Ethernet port (10/100 Mbit) and a SNTP client.
The time for the display can be received from any NTP server using the SNTP
protocol (like your LANTIME), additionally the display is capable of showing text
messages, which are sent by using a special utility. The LANTIME can send an alarm
message to one or two VP100/NET displays over the network, whenever an event
occurs for which you selected the display notification type. If this happens, a scrolling
alarm message is shown three times on the display.
Just enter the display's IP address and its serial number (this is used for
authorisation), which can be found by pressing the SET button on the back of the
display four times. The serial number consists of 8 characters, representing four bytes
in hexadecimal notation.
If you want to use the display for other purposes, you can send text messages to it by
using our command line tool send2display, which can be found on the LANTIME.
This allows you to use the display by CRON jobs or your own shell scripts etc. If you
run the tool without parameters, a short usage screen is shown, explaining all
parameters it may understand. See appendix for a printout of this usage screen.
46