Meinberg LANTIME/GPS Operating Instructions Manual page 98

SNMP branch
mbgLtCfgNotify mbgLtCfgNotifyNTPNotSync
mbgLtCfgNotifyNTPStopped
mbgLtCfgNotifyServerBoot
mbgLtCfgNotifyRefclockNotR
esponding
mbgLtCfgNotifyRefclockNotSy
nc
mbgLtCfgNotifyAntennaFaulty
mbgLtCfgNotifyAntennaRecon
nect
mbgLtCfgNotifyConfigChange
d
mbgLtCfgNotifyLeapSecondAn
nounced
mbgLtCfgEthernet mbgLtCfgEthernetIf0IPv4IP
mbgLtCfgEthernetIf0IPv4Netm
ask
mbgLtCfgEthernetIf0IPv4Gate
way
mbgLtCfgEthernetIf0DHCPCli
ent
mbgLtCfgEthernetIf0IPv6IP1 string (IPv6 IP-
mbgLtCfgEthernetIf0IPv6IP2 string (IPv6 IP-
mbgLtCfgEthernetIf0IPv6IP3 string (IPv6 IP-
mbgLtCfgEthernetIf0IPv6Auto
conf
mbgLtCfgEthernetIf0NetlinkM
ode
For all additional Ethernet interfaces of the timeserver, "If0" only has to be replaced
with "Ifx", where "x" is substituted by the number of the desired Ethernet interface.
Example: The IPv4-address of the timeservers third Ethernet interface can be set with
mbgLtCfgEthernetIf2IPv4IP!
Variable
string(combination
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (combination) (see mbgLtCfgNotifyNTPNotSync) for
string (IPv4 IP-
address)
string (IPv4
Netzmaske)
string (IPv4 IP-
address)
integer (0 =
disabled, 1 =
enabled)
address)
address)
address)
integer (0 =
disabled, 1 =
enabled)
integer (0..4)
98
Data type
) Exactly one, none or a combination of
the following notification types:
email=sending an email
wmail=sending a winpopup-message
snmp=sending a SNMP-trap,
disp=showing on wall mount display,
syslog=sending a syslog-entry
for the event „NTP not synchronized"
the event „NTP Daemon stopped"
the event „Timeserver reboot"
the event „Refclock not ready"
the event „Refclock not synchron"
the event „GPS antenna not connected or
dammaged"
the event „GPS antenna reconnected"
the event „Configuration changed"
the event „Leap second announced"
IPv4-address of first network interface
of the timeserver
IPv4-netmask of first network interface
of the timeserver
IPv4-address of the default gateway of
the timeservers first network interface
Configure the first network interface of
the timeserver with DHCP?
First IPv6-IP-address of the timeservers
first network interface
Second IPv6-IP-address of the
timeservers first network interface
Third IPv6-IP-address of the timeservers
first network interface
Activate autoconf for the IPv6 -
configuration of the timeservers first
network interface?
Configuration of the network-speed and
duplex settings of the timeservers first
network interface
0 = autosensing,
1 = 10Mbit/s half duplex,
2= 10Mbit/s full duplex,
3=100Mbit/s half duplex,
4=100Mbit/s full duplex
Description